Confusion About Adding the following virtualhost info into /etc/httpd/conf.d/rt3.conf

RT Users
1

I’m now to the point where I need to create a virtual host for RT. The Install Guide says to put the following in
/etc/httpd/conf.d/rt3.conf:

ServerName your.rt.server.hostname DocumentRoot /usr/local/rt3/share/html AddDefaultCharset UTF-8

these four lines apply to Apache2+mod_perl2 only: {{{

PerlSetVar MasonArgsMethod CGI
PerlModule Apache2 Apache::compat
RewriteEngine On
RewriteRule ^(.*)/$ $1/index.html

}}}

PerlModule Apache::DBI
PerlRequire /usr/local/rt3/bin/webmux.pl

SetHandler perl-script PerlHandler RT::Mason How is apache going to see this? I tried to put this info into my apache config, but I couldn't start apache because of the following error:

Invalid command ‘PerlModule’, perhaps mis-spelled or defined by a module not included in the server configuration.

I’m confused as to how the virtual host is supposed to be set up. Thanks in advance. Allyn

2

How is apache going to see this? I tried to put this info into my
apache config, but I couldn’t start apache because of the following
error:

Invalid command ‘PerlModule’, perhaps mis-spelled or defined by a
module not included in the server configuration.

I’m confused as to how the virtual host is supposed to be set up.
Thanks in advance. Allyn

you’re trying to use a mod_perl config for RT without mod_perl
installed in your web server.

3

We had this problem on one of our (many) installs. We had to
completely reinstall. It seems that mod_perl did not install properly
and was causing all sorts of problems. I guess it could have been
fixed but we just started over. Since this was a new install for us it
didn’t impact anything. We are building a new server with bugzilla and
RT - RTFM only on it.

The bottom line here (I think) is that mod_perl is the problem.On Mon, 10 Jan 2005 10:23:26 -0600, Allyn Baskerville allynb@adsne.com wrote:

I’m now to the point where I need to create a virtual host for RT. The Install Guide says to put the following in
/etc/httpd/conf.d/rt3.conf:

======================

ServerName your.rt.server.hostname
DocumentRoot /usr/local/rt3/share/html
AddDefaultCharset UTF-8

these four lines apply to Apache2+mod_perl2 only: {{{

PerlSetVar MasonArgsMethod CGI
PerlModule Apache2 Apache::compat
RewriteEngine On
RewriteRule ^(.*)/$ $1/index.html

}}}

PerlModule Apache::DBI
PerlRequire /usr/local/rt3/bin/webmux.pl

SetHandler perl-script PerlHandler RT::Mason ============================ How is apache going to see this? I tried to put this info into my apache config, but I couldn't start apache because of the following error:

Invalid command ‘PerlModule’, perhaps mis-spelled or defined by a module not included in the server configuration.

I’m confused as to how the virtual host is supposed to be set up. Thanks in advance. Allyn

The rt-users Archives

Be sure to check out the RT wiki at http://wiki.bestpractical.com